sc300jz's 5spd swap
#31
Well i just did a oil change and, my rear main seal is leaking like a ****.
Anyways i was wondering if i have to take off the RMS bracket (according to redphoenix) but in this thread this guy didnt. http://www.lexls.com/tutorials/trans...n/removal.html
Also, is there a gasket behind the RMS bracket?
Anyways i was wondering if i have to take off the RMS bracket (according to redphoenix) but in this thread this guy didnt. http://www.lexls.com/tutorials/trans...n/removal.html
Also, is there a gasket behind the RMS bracket?
#32
Lexus Test Driver
iTrader: (44)
Join Date: Jan 2007
Location: Maryland /Germantown
Posts: 5,139
Likes: 0
Received 7 Likes
on
7 Posts
Yes if you remove the RMS bracket you will have to use some rtv to reseal it. it's more expensive with the bracket on it.you can just buy the seal itself and replace it, it's not to bad.
#33
I already ordered the seal and am just wondering if i were to take off the bracket would i need a gasket (or would it come with the seal)
#40
Yes i am, we were able to get it to run after we bought it wasn't in the best shape. Shifted a little rough, but after draining the transmission i could see why since white fluid came out then orange. I'm sure with new tranny fluid it'll run completely fine.
#42
Driver School Candidate
iTrader: (1)
Join Date: May 2010
Location: vee aye
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
clean swap so far i used yours and the other thread to do my swap last weekend man u have to cut alot for that shifter, good luck
ps u got that clutch master in perfect took me a couple trys to get the pedal to sit right slso my harbor frieght hole saw broke on me as well
ps u got that clutch master in perfect took me a couple trys to get the pedal to sit right slso my harbor frieght hole saw broke on me as well
#43
Thanks, tomorrows the big day
BUT i have a few questions hopefully someone can chime in.
Am i suppose to grease / lube anything on the manual tranny. I THINK your suppose to lube the tip of the spline where it connects to the pilot bearing. Can anyone confirm?
Do i need 31481A from the manual tranny? Or does the auto have one as well? If it doesn't i guess i gotta go make a run to my buddies place to rip it off the SC donor.
BUT i have a few questions hopefully someone can chime in.
Am i suppose to grease / lube anything on the manual tranny. I THINK your suppose to lube the tip of the spline where it connects to the pilot bearing. Can anyone confirm?
Do i need 31481A from the manual tranny? Or does the auto have one as well? If it doesn't i guess i gotta go make a run to my buddies place to rip it off the SC donor.