Problems starting from cold start
#1
Lead Lap
Thread Starter
iTrader: (2)
Join Date: May 2009
Location: VA
Posts: 557
Likes: 0
Received 0 Likes
on
0 Posts
Problems starting from cold start
Hi this problem only occurs from a cold start. I have a video recorded of what happens usually. It use to take 2 tries. 1 Fail then its good. But last night it took 3 tries, 2 fails then it was good im afraid this problem is going to only get progressively worse.
I had my started test said it was good. What could cause this problem
95 sc400 126k. Heres a video I recorded
I feel like this also is the same problem why once in a while when I am not accelerating and hit low speeds of around 15 (coming to a stop) my car will stall (Its automatic)
View My Video
(might need to turn volume up)
I had my started test said it was good. What could cause this problem
95 sc400 126k. Heres a video I recorded
I feel like this also is the same problem why once in a while when I am not accelerating and hit low speeds of around 15 (coming to a stop) my car will stall (Its automatic)
View My Video
(might need to turn volume up)
Last edited by nfordhk; 01-09-10 at 09:53 AM.
#4
Sounds like the starter bendix (gear assembly on end of starter motor) is going bad, starter motor runs but doesn't turn the engine. That little gear assembly has an engagement clutch in it & it's slipping (worn out).
Thread
Thread Starter
Forum
Replies
Last Post
alrogers
RX - 2nd Gen (2004-2009)
6
02-24-18 09:24 AM