Hey all! Just wondering if anyone knew where to begin troubleshooting this code..? I did a search for air mix servo, but all I found was a few articles on the vacuum servo on the firewall just behind the ABS unit. All the connections there look good, not sure if it's actually operating.. I don't care about the car heater..i live in Florida after all. I just want cold air! Right now, it never seems to get COLD or HOT when the heater or air is on, just warm or cool.. Could it just be something as simple as a shorted out wire or something?? No leaks in the system (checked out by shop) and freon charge is good...no blinking AC light, etc.. otherwise system seems good.

Thanks in advance to all that respond..

 

it's already been discussed, recently even, within the past week actually... all the info is here..

 

Yes, I posted this because I wasn't sure you were going to respond to the last round of questions- no disrespect intended..