Vibrating License Plate Frame
Thread Starter
Driver School Candidate
Joined: Nov 2021
Posts: 49
Likes: 7
From: NC
I am also having some rattling sound issues on my 2019 NX300. Mine sounds like it is coming from the right passenger side area and it is a slight vibrating sound that I cannot specifically pinpoint. Did the replacement of glove compartment door solve this rattling issue for you? This is for @PearlNXt and the picture of the invoice that you posted above.
Driver School Candidate
Joined: Jul 2017
Posts: 18
Likes: 6
From: Alberta
No, the rattling issue was not solved after they replacing the broken tab. I had to come back 2 more trips before they finally found the rattle coming from the passenger A pillar and fixed it. Those are the only issues I had with my NX. It's been a great car now after almost 6 years
. @JermSJ
. @JermSJ
Last edited by Onekoolguy; Jan 20, 2022 at 12:45 PM.
Rookie
Joined: Aug 2021
Posts: 39
Likes: 13
From: MA
Driver School Candidate
Joined: Jul 2021
Posts: 20
Likes: 5
From: KY
I got mine last night, I got one that has the drains but it was already too dark out to throw it on. Gonna get it done tomorrow and will post an update. I also ordered a black stainless set of new screws which are due in tomorrow since the ones I have on from when I bought the car are rusting a bit.
Advanced
Joined: Feb 2005
Posts: 563
Likes: 162
From: Mid-West
Driver School Candidate
Joined: Jul 2021
Posts: 20
Likes: 5
From: KY
Got mine installed, I lost the tinted plate cover but the loss of the rattle totally makes up for it.
is the one I purchased from Amazon, although it comes with two and I don't have to use a front plate in my state so I have an extra.
Rookie
Joined: Aug 2021
Posts: 39
Likes: 13
From: MA
Got mine installed, I lost the tinted plate cover but the loss of the rattle totally makes up for it. Silicone Plate is the one I purchased from Amazon, although it comes with two and I don't have to use a front plate in my state so I have an extra.
This is a crazy long thread for such a minor, easily solvable issue!
In Massachusetts we have plates on the front and rear. I used both silicone covers/sleeves/frames (whatever they're called) and I actually think they look pretty good. I have black plastic screws too so I won’t get rust in the rough winters we have.
This is a crazy long thread for such a minor, easily solvable issue!
This is a crazy long thread for such a minor, easily solvable issue!
Rookie
Joined: Aug 2021
Posts: 39
Likes: 13
From: MA
Maybe you could on top of the silicone. The silicone kind of wraps tightly around the edge of the license plate. I don’t think you could fit a clear cover under the silicon. But over it maybe. I don’t use any license plate cover on the front or rear.
