1st GEN GS300 rotors
#1
Pole Position
Thread Starter
1st GEN GS300 rotors
i'm trying to take the rotors off of my 1st gen GS3, the chilton manual says to remove the mounting bolts and the rotor will come off, problem is i can't see anything that looks remotely like a bolt on the front of this rotor. any ideas? thanks.
#6
Pole Position
Thread Starter
LOL, i temporarily abandoned the project. i don't want to hit too because it may cause damage to the hub. i was going to see if i couldn't get something stronger than WD40 and try spraying the key areas.
Thread
Thread Starter
Forum
Replies
Last Post