Windshield Washers
Thread Starter
Advanced
Joined: Mar 2010
Posts: 645
Likes: 151
From: FL
Windshield Washers
The driver side washer spray on my '11 LS460 is way too low on my w/s to do any good. Is there an adjustment on these? I did try to clean the nozzle with no results. It does not seem to be a pressure problem. The nozzle itself appears to be in a fixed position on the under side of the hood.
Thread Starter
Advanced
Joined: Mar 2010
Posts: 645
Likes: 151
From: FL
I ended up ordering a new nozzle. Compressed air didn't help. Actually the Lexus shop manual says to replace them if the spray is erratic. $20 shipped Amazon.
This is the first time I've used my hard cover manuals that I got when from the dealer when I purchased my 2 year old '11 LS460 back in 2013. There are 7 books included and they stand 15 inches high. Retail for these was about $1700 at the time that the dealer got for me for around $500. They're quite good from a procedure standpoint. Lots of pics.
This is the first time I've used my hard cover manuals that I got when from the dealer when I purchased my 2 year old '11 LS460 back in 2013. There are 7 books included and they stand 15 inches high. Retail for these was about $1700 at the time that the dealer got for me for around $500. They're quite good from a procedure standpoint. Lots of pics.
Thread Starter
Advanced
Joined: Mar 2010
Posts: 645
Likes: 151
From: FL
Turns out the problem was the valve to which the 3 hoses attach, the supply and then 1 for each nozzle. This part with the hoses is attached to the underside of the hood under the insulation piece. This I removed for easier access. This apparently is a part that not uncommonly goes bad. Here it is:
Last edited by jud149; Oct 18, 2018 at 01:18 PM.
Thread
Thread Starter
Forum
Replies
Last Post
