P0336 code

Reply Subscribe

Thread Tools

Search this Thread

Nov 5, 2012 | 06:29 PM

kyddo112

Thread Starter

Pit Crew

Joined: Oct 2007

Posts: 174

Likes: 2

From: VA

P0336 code

I've been having this code keep popping up(keep clearing with a cheap scan tool but it comes back after 2 or 3 starts). It's for the crank position sensor. I've replaced the sensor twice now. It runs perfectly fine, accelerates as it should, idles well, no misfires or anything. The harness is covered with a wire loom but from what I can see there's no damaged wires. Does anyone know which pins the crank sensor is on the ecu? There isn't relearn process for it is there?

Last edited by kyddo112; Nov 5, 2012 at 06:33 PM.

Nov 5, 2012 | 06:51 PM

LScowboyLS

Lexus Champion

Joined: Dec 2011

Posts: 4,078

Likes: 87

From: Birmingham, AL

have you been replacing the crank position sensor with the genuine Toyota (Nippon Denso) part or an aftermarket?

Nov 5, 2012 | 07:04 PM

kyddo112

Thread Starter

Pit Crew

Joined: Oct 2007

Posts: 174

Likes: 2

From: VA

Quote:

Originally Posted by LScowboyLS

have you been replacing the crank position sensor with the genuine Toyota (Nippon Denso) part or an aftermarket?

Aftermarket from advance auto parts

Nov 5, 2012 | 10:21 PM

LScowboyLS

Lexus Champion

Joined: Dec 2011

Posts: 4,078

Likes: 87

From: Birmingham, AL

I would check the wiring from the ECU to the crankshaft position sensor with an ohmmeter and also check the voltage to it

Nov 6, 2012 | 06:37 AM

kyddo112

Thread Starter

Pit Crew

Joined: Oct 2007

Posts: 174

Likes: 2

From: VA

Quote:

Originally Posted by LScowboyLS

I would check the wiring from the ECU to the crankshaft position sensor with an ohmmeter and also check the voltage to it

does anyone have a wiring diagram or a schematic of the crank position sensor to the ecu?

EDIT: Nevermind. Found the diagram on Lextreme. Going to test the harness for a short.

Last edited by kyddo112; Nov 6, 2012 at 10:29 AM.

Jul 6, 2024 | 07:51 AM

blkstealthpaid4

Advanced

Joined: May 2001

Posts: 651

Likes: 7

Did you test the harness for short?

Quote:

Originally Posted by kyddo112

does anyone have a wiring diagram or a schematic of the crank position sensor to the ecu?

EDIT: Nevermind. Found the diagram on Lextreme. Going to test the harness for a short.

I am having the same issue.I got mine for rock auto.Wondering if I have a short in mine.