Downstream O2 Sensor Replacement
Thread Starter
Driver
Joined: Oct 2019
Posts: 53
Likes: 2
From: ca
Downstream O2 Sensor Replacement
Hi all,
I have a P0136 "heated oxygen sensor 2, bank 1" code on my 2000 LS400. A couple questions:
1. Sensor 2 Bank 1 is the driver's side downstream sensor, correct?
2. To replace it, am I able to cut the old O2 sensor off and splice in the new sensor to avoid tearing apart the interior carpet?
Thanks!
I have a P0136 "heated oxygen sensor 2, bank 1" code on my 2000 LS400. A couple questions:
1. Sensor 2 Bank 1 is the driver's side downstream sensor, correct?
2. To replace it, am I able to cut the old O2 sensor off and splice in the new sensor to avoid tearing apart the interior carpet?
Thanks!
Racer
Joined: Nov 2015
Posts: 1,786
Likes: 412
From: NJ
1) Yes, Sensor 2 Bank 1 is the Left/Driver's side (in the US) downstream O2 Sensor
See this post for documentation:
https://www.clublexus.com/forums/per...ml#post2486474
2) Sure, that's possible as long as you insulate the wires properly. Ideally with a couple of layers of heat shrink or tightly wound electrical tape after you solder the wires together. It's ideal to disassemble and use the connector of course
See this post for documentation:
https://www.clublexus.com/forums/per...ml#post2486474
2) Sure, that's possible as long as you insulate the wires properly. Ideally with a couple of layers of heat shrink or tightly wound electrical tape after you solder the wires together. It's ideal to disassemble and use the connector of course
Last edited by CELSI0R; Dec 27, 2023 at 08:34 AM.
Thread
Thread Starter
Forum
Replies
Last Post
hummingbir
RX - 2nd Gen (2004-2009)
7
May 26, 2022 10:23 AM
SICK350
ES - 1st to 6th Gen (1990-2018)
7
Mar 11, 2014 05:20 PM
swat1727
GS - 2nd Gen (1998-2005)
0
Oct 1, 2008 11:50 AM
