new black guages!
Trending Topics
ClubLexus Stories
Celebrating Lexus & Toyota from Around the Globe
Lexus NX 350h: A Fuel-Sipping Secret Hot Hatch???
Michael S. Palmer
5 Best & 5 Worst Lexus Daily Drivers
Joe Kucinski
Top 5 Hottest Lexus & Toyotas in 2026 (Hardest To Buy)
Brett Foote
2026 Lexus IS 350 F Sport Review: The Last of Its Kind Still Rocks
Michael S. Palmer
Top 10 Most Confusing Things Lexus Has Ever Done!
Joe Kucinski
2026 Lexus ES Review: Lexus Re-Embraces Founding Principles
Michael S. Palmer
10 Lexus Bargains That are Cheaper Than a New Toyota RAV4
Joe Kucinski
8 Weirdest Things Lexus Has Ever Built
Verdad Gallardo
10 Lexus Designs That Have Aged Like Fine Wine
Verdad Gallardo
Thread Starter
Lead Lap
Joined: Jul 2003
Posts: 407
Likes: 0
From: California
icouple of bad things not everything lines up maybe i have to open it up to adjust again... hopefully it would. the turn signals dont line up perfectly,air bag is a picture not the word, i cant see the icon when i turn on high beams. so i pretty much have to take it out again and see whats getting covered up. other then that it looks great. now i need some red or blue needles!i got these thinking it would fit cuz it said sc400 but i guess not every indictor is the same
Last edited by DavE713; May 24, 2007 at 01:20 PM.
Kinda reminds me of the Civic aftermarket overlays. Maybe I'm thinking of the Integra overlays, one of the two.
Looks like you had to cut a good bit since the side gauges are not cut out to accept the two slider gauges on the side. Also, I'm guessing it's an overlay? If not and it is the actual face plate let's see how it looks where you trimmed the sides to make the two slider gauges slide in for the gas and temp. I'd be interested in seeing how you did it. (daytime pics)
If I am losing anyone here, these two side gauges slide in and lock to the face plate. (gas and temp) They are separate from the faceplate itself. Up there it has a complete one piece circle so they can't slide in.
(on the right)
Looks like you had to cut a good bit since the side gauges are not cut out to accept the two slider gauges on the side. Also, I'm guessing it's an overlay? If not and it is the actual face plate let's see how it looks where you trimmed the sides to make the two slider gauges slide in for the gas and temp. I'd be interested in seeing how you did it. (daytime pics)
If I am losing anyone here, these two side gauges slide in and lock to the face plate. (gas and temp) They are separate from the faceplate itself. Up there it has a complete one piece circle so they can't slide in.
(on the right)
