thread pitch on REAR axle spindle
Thread Starter
Driver
Joined: Jun 2017
Posts: 142
Likes: 11
From: CA
thread pitch on REAR axle spindle
so i literally spend HOURS of researching the stupid axle spindle thread specs.
Already got full set of axle rethreading dies. and largest there is m24x2.0 and m24x1.5 and everything else below that, but nothing fits!!!!!
Anyways, to keep it short, if anyone knows size for REAR AXLE SPINDLE THREAD please just let me know.
part #9017726001
Already got full set of axle rethreading dies. and largest there is m24x2.0 and m24x1.5 and everything else below that, but nothing fits!!!!!
Anyways, to keep it short, if anyone knows size for REAR AXLE SPINDLE THREAD please just let me know.
part #9017726001
Thread Starter
Driver
Joined: Jun 2017
Posts: 142
Likes: 11
From: CA
So I have caliper tool, and I measured the thread on the axle it’s in metric “25.63mm” which translates into “1.008inch” could the Lexus use 1 inch thread on cars? That doesn’t seem like a reasonable thing.
Lexus Fanatic
Joined: Sep 2010
Posts: 26,024
Likes: 4,319
From: Alberta
Are the threads gnarled up on the axle? I have no idea what the thread pitch/diameter is sorry I can't be of any help. If it was me I'd take the nut to a bolt supply house and find a bolt the nut threads on to.
Thread Starter
Driver
Joined: Jun 2017
Posts: 142
Likes: 11
From: CA
Trending Topics
Thread Starter
Driver
Joined: Jun 2017
Posts: 142
Likes: 11
From: CA
UPDATE.
so I didn’t find the thread specs so for those who will come by this thread I’m sorry lol I even looked on Russian sites but no luck... what I did in my case though, is cut 1/8th of inch of axle shaft (cut to your need) my thread wasn’t really bad but I had to cut 1/8th. and use dremel of whatever u have to remove the edge and my thread was good to go. I’m not responsible if you mess it up. Gotta have those hands growing right lol (I know I messed up my thread myself
)
so I didn’t find the thread specs so for those who will come by this thread I’m sorry lol I even looked on Russian sites but no luck... what I did in my case though, is cut 1/8th of inch of axle shaft (cut to your need) my thread wasn’t really bad but I had to cut 1/8th. and use dremel of whatever u have to remove the edge and my thread was good to go. I’m not responsible if you mess it up. Gotta have those hands growing right lol (I know I messed up my thread myself
)
Thread
Thread Starter
Forum
Replies
Last Post