engine and vsc lights on
The following users liked this post:
sy02 (01-24-17)
#19
Tech Info Resource
iTrader: (2)
O2 sensors work by comparing exhaust to ambient air. There are small holes in the outer shell of the device for ambient air to get in. If they are full of water, the O2 sensor will appear to be inoperable so the ECM will set DTCs based on the sensor being unresponsive. Once they dry out, you should be fine again.
#20
Lead Lap
iTrader: (2)
O2 sensors work by comparing exhaust to ambient air. There are small holes in the outer shell of the device for ambient air to get in. If they are full of water, the O2 sensor will appear to be inoperable so the ECM will set DTCs based on the sensor being unresponsive. Once they dry out, you should be fine again.
Thread
Thread Starter
Forum
Replies
Last Post