Hello all,

I'm going to remove the my OEM bumper mount exhaust ends and replace with round straight cut tips..
Can any one tell me what lengthens diameter of tip I need to clear the bumper?
Was looking at the magnaflow products.
Any suggestions?

 

I believe someone post they are 2.5" inlet and 3.5" outlet. 4" long. I haven't been able to find any though. If you find some post em up.

 

i have the ISS exhaust. just went outside to measure because i love this community...and im bored.

if you are trying mimic that one...the upper tip is 5" long. the lower is 4" long....

 

Check out the QCisf build thread.