Quick Release Front Lip
#1
Driver School Candidate
Thread Starter
Quick Release Front Lip
Hey guys, so I've always been searching for an idea like this in the forums and never really found any write ups so i decided to create this one. I've always had bad luck with using self tapping screws to hold on a lip so i switched to the nut and bolt method but it's a pain taking off these bumpers just to remove a lip. So I went down to Harbor Freight and picked up a Threaded Inserter Rivet kit so that I could just thread the front lip to that.
Threaded Insert Rivet Kit from Harbor Freight for about $20I used the 1/4th insert and lined it up directly with the mounting holes for my Seibon Carbon Fiber front lip and riveted them into the bottom of the bumper.
1/4th threaded rivets into the bumper
Then all that was left was to just simply screw in my lip using bolts and washers.
Bolted on and added washers
Mounted on within 5 minutes
And simple as that, my lip is bolted on and it is super simple to remove (in case you need to get your car serviced or, like me, had issues getting onto an alignment rack). It's super sturdy and really quick to take off and put back on so I hope this helps anyone else that constantly takes off their lips! Make sure to give me a follow on ig @mv.is for more updates on my build!
Last edited by mv250; 12-13-17 at 12:41 PM.
The following 3 users liked this post by mv250:
#6
Will this work for non-f sport model?
Trending Topics
The following users liked this post:
zhifan1 (02-03-18)
#10
Driver School Candidate
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
Bonkers501
IS - 3rd Gen (2014-present)
2
10-02-17 09:06 PM
handoverfi
GS - 2nd Gen (1998-2005)
8
12-07-08 02:09 PM