How to take off Factory spoiler is250
#2
The Trunk lid spoiler? They are affixed with double sided tape. You just have to carefully yank it out. You can use a nylon string to loosen the tape. Lots of patience and some sweat. Some sore fingers for sure.
My bad, did not know there are 3 bolts...
Good luck.
My bad, did not know there are 3 bolts...
Good luck.
Last edited by mandyfig; 07-10-17 at 08:50 AM.
#4
Instructor
Dental floss works great and doesn't scratch the paint.
#5
Driver School Candidate
Join Date: Jul 2017
Location: OH
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Are you sure about that? Mine definitely has two bolts holding it in place as well as double sided tape.
Trending Topics
#10
Pole Position
DO NOT just yank it off.
It has had double sided tape AND 3 bolts inside.
Use thin wires like fishing wire to cut off the double sided tape then open your trunk and unbolt the bolts inside. 1 right, 1 left, and 1 in the center.
The bolts are suuuuper tight so spray some wd40 and then you'll need a long extension with a 10mm hex (I think).
It has had double sided tape AND 3 bolts inside.
Use thin wires like fishing wire to cut off the double sided tape then open your trunk and unbolt the bolts inside. 1 right, 1 left, and 1 in the center.
The bolts are suuuuper tight so spray some wd40 and then you'll need a long extension with a 10mm hex (I think).
Thread
Thread Starter
Forum
Replies
Last Post