Engine Start Button Swap
#1
Driver
Thread Starter
Engine Start Button Swap
Has anyone actually swapped out their engine start button with an aftermarket one? I have seen the Youtube from CL showing how to do it, but was just curious to see if anyone has actually done it. Also, can you only swap it out the one in CL video (Part# MS422-00003)?
#3
Driver
Thread Starter
#6
Driver
Thread Starter
Yeah they were pretty expensive on ebay. I might just hold off on that for a while then.
#7
Lead Lap
iTrader: (8)
Open the side panel with a trim tool or by hand, several banana clips hold it in place.
Pull the lower dash panel outwards, several banana clips hold it in place.
Repeat for the section under the start/stop button.
There is a clip on the top and bottom of the backside of the switch, press the lower section to release, then push the entire switch out.
Unplug the old switch and plug the new switch in.
Make sure the switch works and reverse the order to reassemble.
Enjoy. Total time: 5 minutes (for pictures) or less.
Pull the lower dash panel outwards, several banana clips hold it in place.
Repeat for the section under the start/stop button.
There is a clip on the top and bottom of the backside of the switch, press the lower section to release, then push the entire switch out.
Unplug the old switch and plug the new switch in.
Make sure the switch works and reverse the order to reassemble.
Enjoy. Total time: 5 minutes (for pictures) or less.
Trending Topics
#8
Driver
Thread Starter