Headlights low
Thread Starter
Driver
Joined: May 2014
Posts: 119
Likes: 3
From: california
See the white hotspot on those pictures? The passenger side is like a half oval under the cutoff, which is how it should be.... The driver side looks a tad bit off to me, like the hotspot is expanding the width of the beam. Maybe it's how the IS projectors are, I haven't really taken a look at mine.
Did you ever look to see if those ballasts you found go to your low beams or not?
Did you ever look to see if those ballasts you found go to your low beams or not?
There are four ballast two to the dogs and two to the low beam.
I don't know if you fixed your aim since the last picture, but as mentioned above, please fix that aim.
Thread Starter
Driver
Joined: May 2014
Posts: 119
Likes: 3
From: california
I don't know if I can adjust the driver side any higher because the lifter already popped out of the joint once.
I am going to lower the passenger side
And I can't aim the light left to right. I for some reason can't get the screw driver into that slot.
CL Community Team
Joined: Dec 2005
Posts: 5,707
Likes: 342
From: NJ
Well few problems I can't get that bulb put its impossible with the room left at the driver side. Would have to remove the whole bumper.
I don't know if I can adjust the driver side any higher because the lifter already popped out of the joint once.
I am going to lower the passenger side
And I can't aim the light left to right. I for some reason can't get the screw driver into that slot.
I don't know if I can adjust the driver side any higher because the lifter already popped out of the joint once.
I am going to lower the passenger side
And I can't aim the light left to right. I for some reason can't get the screw driver into that slot.
Thread Starter
Driver
Joined: May 2014
Posts: 119
Likes: 3
From: california
tired of doing **** on this car.
Thread
Thread Starter
Forum
Replies
Last Post