I just bought a set of AVS visors, and I have a few questions on installing them. For the driver and passenger visors, there's a tab that goes under the triangle plastic part, I was wondering if you guys trim about one inch on top of the tab to have it fit? Or what methods did you guys use to make it sit flush with the chrome?

 

just peel the tape and stick it on bro!!

 

lol If I do that, then there will be the tabs at the end just chillen, and it'll look weird, but I heard people tuck the tab under the plastic piece, and if I do that, then the chrome on the car doesn't line up to the chrome on the visors

 

Thats why most ppl have bought the JDM visors instead. But from what I have read everyone has either cut it off or dremeled it off

 

I just shoved mine under the plastic piece lol. From my memory, it looked pretty good. I haven't looked at it closely for a long time though.

 

I don't have money for the JDM ones haha! and alright ima try to shove mines in there and if there's some trimming needed then ill go for it! Thanks alot guys.

 

go for it Tung lol

 

I had to shave a small portion of mine off.

 

i just stuck mine in between the plastic piece. matched up pretty good!

 

from what I remember, I had to shave a portion off of it to make it fit better

 

Says the guy driving a Lexus

I just shoved that piece under the rubber part of the window and it was fine......until the visors started to warp lol

 

thanks guys! I guess I'm going to be shaving about an inch off

 

don't shave nooooo...i'm guessing the way i told u didn't work... thats strange though...

 

I just ordered a set for my 350, i hope I dont have to do this.

 

that was my issue when i installed mine. It will fit behind the triangle piece, slowly put it in and you should be good to go. I have had no issues with mine yet, 10 months strong.