When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
yeah. cut off the LED light already there, strip the wire so the copper is showing, then match up the red and black with your LED strip, and use a connector (autzone, reillys) or electrical tape to connect the wires
Way To Go! Nice Job. I found it's not too hard to do these types of mods or LED in general. My best advice for the easy quick is to use the existing LED harness , just disconnect from the existing one LED in the well. Then using T-Taps from Autozone / Radioshack or such, just t-connect to the main wire - then install proper connector on your new wire (going to your LED Strip that is) and connect to the T-Tap! Boom, instant much brighter LED and footwells