How to turn plastic screws at wheel wells back after fog light replacement?
#1
Intermediate
Thread Starter
How to turn plastic screws at wheel wells back after fog light replacement?
Hi all,
I did a search on how to replace the fog light bulbs and succeeded in doing so; however, how do you turn those plastic screws (two on each wheel well by the bumper) back 90 degrees clockwise?
When I turned them 90 degrees counter clockwise to take them out, I felt a click, but when I put them back in to re-fasten them, they kind of spring back to the unlock position.
I did a search on how to replace the fog light bulbs and succeeded in doing so; however, how do you turn those plastic screws (two on each wheel well by the bumper) back 90 degrees clockwise?
When I turned them 90 degrees counter clockwise to take them out, I felt a click, but when I put them back in to re-fasten them, they kind of spring back to the unlock position.
#5
Intermediate
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
ThermonMer
IS - 2nd Gen (2006-2013)
2
03-22-11 08:39 AM
ezlyf
GS - 2nd Gen (1998-2005)
26
04-01-02 10:56 PM