Originally Posted by TETO

HOW to remove the one on the back ???

i can't remove it ..

Originally Posted by Initial_K

First get a small thin knife like this. If you have a very thin flathead that will work too, but all my flathead were too big. You will need this something thin and strong enough to detach the clips from the socket.



There are four clips holding the dome cover together. Unclip the two that I highlighted using the edge of the knife. Shouldn't take too much force to unclip it from the socket. Once you detach the two clip, it should come down easily.



Next, don't twist on the light bulb. Simply pull straight down.

Hope this helps.

Originally Posted by DJSirkit13

I just ordered 5 led boards from nigel jdm parts. but having a few issues with this.

1.) I can't get the front cover of (yes i did remove the two screw)
i searched but couldn't find any DIY with pics and I knw for a fact alot of ppl have changed the bulbs so please help, ive read to pull the front down hard as possible but which front the one by the windshield or the side facing the rear?

2.) Has anybody ordered the LED boards from nigel and are they really as bright as some people say they are?

3.) if they are really that bright do I need two in the rear dome or is one enough? ( PS I plan on putting two in the rear and 3 in the Front but if i only need one in the back then i can use the xtra for the trunk)

4.) Where in the front & rear dome light housing did you stick the board two I wouldn't think it would be safe to stick some thing to the connectors that hang dwn but if there is no danger y not.

5.) can those led boards be used for the door courtsey and the mirrors again where and how would i stick them too.


Thankyou & please help really need help with these problems want to get it all done within the next couple of days