Was wondering if anyone had the below JAOS mud flaps installed onto their GX 2nd Gen rig? They are for the Prado 150. However, pre-made holes for those m6 tapping screws and washers doesn't seem to line up to the GX's existing mud flaps/inner wheel well as shown from the instructions. Any insights to your installation process would be greatly appreciated.



https://www.blackhawkjapan.com/products/jaos-b622065f
https://www.blackhawkjapan.com/products/jaos-b622065r

Install instructions - https://www.jaos.co.jp/support/download.php?id=431

(Photos below are for reference. Not my personal rig. ^_^)

 

Why ? ...............

 

Oh man those look badass. Do they make them with Yosemite sam?

I’m a big fan of mudflapa. (More for snow than mud)

 

Those look amazing. I gotta get a set eventually. Since I'll be trimming my rear bumper not sure how I'm going to install them...

 

eBay has them for about $377.00 for the whole set of front and rear. If just the rear... you're looking at about $150 for just the rear set.

If obtained directly from some Japanese retailer, it should be under $300 shipped to the states. Hope more people find these as nice looking as I do.

But still need some clarity on the installation instruction... sigh...

 

Just would need the rear. I wonder if my offroad shop up here could parse and do the install then provide some thoughts and info on the install.