E-Z Pass placement
#31
Lexus Fanatic
Thread Starter
Looks good, how does it look from the back?
The following users liked this post:
JellyBean (08-12-17)
#34
Driver School Candidate
I've got a TXTAG toll pass here in Texas. It's shaped like a 1"x2" credit card with an embedded chip. Put it about an inch or so below the mirror mount. High enough so it can't be seen from the inside yet low enough to be below the dots on the windshield. Have yet to test if it works there, but it was mounted according to the instructions that came from the toll agency.
#35
Lexus Test Driver
I've got a TXTAG toll pass here in Texas. It's shaped like a 1"x2" credit card with an embedded chip. Put it about an inch or so below the mirror mount. High enough so it can't be seen from the inside yet low enough to be below the dots on the windshield. Have yet to test if it works there, but it was mounted according to the instructions that came from the toll agency.
You might be able can cut out the little microchip from the toll tag and tape just the chip to the inside of your windshield up where the dots are located using a ¾" x ¾" piece of clear shipping tape you can get from a UPS or FedEx shipping store. Or, you can tape the microchip to the back of your rearview mirror and run a test to see if the transponders will pick it up. I know it will be picked-up on some vehicles. Another place is to tape the microchip on the inside of your sunroof glass or the upper side of the sunroof shade (if you can gain access to it)...unless you oftentimes travel with the sunroof or shade open.
Some toll tag microchips have a built-in antenna.
Last edited by bclexus; 08-11-17 at 07:55 PM.
#36
I've been following this thread wondering what's the big deal about attaching the "EZ-Pass" to the back of the windshield and now (thanks to Joeb427's link) I see that the EZ Pass is a heck of a BIG deal! Wow! What a hunk of plastic! I have no useful suggestions because here in Texas we use an unobtrusive 1.5" square sticker with the chip embedded in it. Nice thread, though!
Last edited by JellyBean; 08-12-17 at 11:28 AM.
#37
When I bought the car the dealership gave me a Lexus E-Zpass holder that suction cups to the windshield. Mine is in the far right bottom corner. Hardly noticeable and works perfectly
Thread
Thread Starter
Forum
Replies
Last Post
JCtx
RC F (2015-present)
28
03-11-19 06:11 PM