Can you please post instructions for us. I want to take mine to get installed, but want to move sure they do it right since they have to take off my steering wheel and all.!!

 

Does anyone know what size pin and what type of pin I need to buy to install the fogs with the oem stalk? I figured out the wiring now I just need the pin for the k23 harness

Thanks

 

I am working on installing fogs using the stalk on my IS350. Can you tell me what wiring setup you are using? I can turn mine off and on using the stalk but I want the fog dash indicator to work. I believe it has to do with the third pin on the new stalk but not sure what to run to it. Maybe tap the signal wire that goes to the relay??

If you are looking for the pins for K23 try this guy on eBay. They are the exact pins and have a 8" wire already attached. MUCH cheaper than buying the wire kit from Lexus/Toyota. The pin PN for the K23 connector is 82998-12870.

http://www.ebay.com/itm/Repair-terminal-for-Toyota-applications-mods-camera-cruise-ECU-ECM-/191328057918?_trksid=p2141725.m3641.l6368

 

How can my non f sport run the fogs independently without the headlights being on.i would like to be able to turn them on and off when I want to. if someone could let me know thanks a lot.

 

If there is a will there is always a way!

 

Sorry about digging old thread, but has anyone got this successfully done other than PK_Celsior?

I installed Fog stalk, but unable to wire them yet.

 

+1 for reviving this retired thread. Any finalized DIY write it to PK_Celsior's mod?

 

did you guys still need help with the fog light indicator???

 

i think it was on my reply in 2014. All you need is to add a wire to the BCM right next to the CAN-BUS line.

if you’re interested I’ll pull out my old notes and post it up later

 

I'm definitely interested, especially if it will also work on the IS. TIA

 

Absolutely! Just acquired the OEM fog light stalk.

 

Walter can you repost the link for us here.

I'm trying to get the multi-function switch to work on my 2018 GS350. I would like to see how you set up the wiring for OEM multi-function switch (84140-30360) to work with the foglights. The 2016-2020 GS350 do not have the foglight symbol on dash display.

 

I have to look at my old notes but I think there are three extra terminals from the original switch. One in and two out(one for front foglight and one for rear). What foglight wiring relay kit are you using?

 

I'm using the aftermarket Spyder Auto wiring assembly (9044311) for the GS350. I'd like to know the correct way to wire the multi-funtction switch (Lexus Part #84140-30360) without having to run a wire through the firewall.