Rubbing issues
Thread Starter
Rookie
Joined: May 2013
Posts: 54
Likes: 11
From: tx
Rubbing issues
I have vossens on my car 20x9 245/35/20 front.... 20x10.5 rear 275/30/20
Tanabe nf210 springs
I'm rubbing in the front real bad against the plastic fender well cover.... Do people normally remove this?
I'm rubbing in the rear also on dips... I had my back panel trimmed but still rubs
Any advice on these issues ????
Tanabe nf210 springs
I'm rubbing in the front real bad against the plastic fender well cover.... Do people normally remove this?
I'm rubbing in the rear also on dips... I had my back panel trimmed but still rubs
Any advice on these issues ????
The 245/35's in front are too big. You need to run a 245/30 up front. Trust me, I just went through this. The rear, without knowing offsets, is probably rubbing on the bumper tab towards the back of the fender. Did you have that trimmed as well?
Thread Starter
Rookie
Joined: May 2013
Posts: 54
Likes: 11
From: tx
It's not rubbing on the bumper tab
Thread
Thread Starter
Forum
Replies
Last Post
Den350
IS - 2nd Gen (2006-2013)
8
Sep 29, 2015 01:43 PM
cubabarber
GS - 3rd Gen (2006-2011)
2
Jun 6, 2012 12:11 PM
