gs430 ECU Pinout and Wiring Diagrams
#1
Driver School Candidate
Thread Starter
gs430 ECU Pinout and Wiring Diagrams
Hey Guys,
Working on swapping the 3uz-fe from my totalled GS430 into my Truck that currently does not have a motor.
Either way I needed the wiring diagrams and ecu pinouts for obvious reasons, so I figured I'd share with you guys.
I'm sure someone will find these useful.
The schematic is not in order but you get the gist
Working on swapping the 3uz-fe from my totalled GS430 into my Truck that currently does not have a motor.
Either way I needed the wiring diagrams and ecu pinouts for obvious reasons, so I figured I'd share with you guys.
I'm sure someone will find these useful.
The schematic is not in order but you get the gist
The following users liked this post:
firelizard (03-09-18)
#5
Driver School Candidate
Join Date: Feb 2019
Location: ca
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
3uzfe ob2 wiring diagram
hi guys
does anyone have the 3uzfe obd2 wiring diagram?
ecu model is 2006 , 89661-50710
i have the obd2 socket diagram, also connected +12v , gnd, can high and can low wires, but still it doesn't connect to diag device
what should I do?!
does anyone have the 3uzfe obd2 wiring diagram?
ecu model is 2006 , 89661-50710
i have the obd2 socket diagram, also connected +12v , gnd, can high and can low wires, but still it doesn't connect to diag device
what should I do?!
#6
Transmission control wiring is all the same, but the 430 ECU did not have the pins for those controls.
Trending Topics
#9
Driver School Candidate
Join Date: Dec 2015
Location: Gauteng
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
#10
Hey Guys,
Working on swapping the 3uz-fe from my totalled GS430 into my Truck that currently does not have a motor.
Either way I needed the wiring diagrams and ecu pinouts for obvious reasons, so I figured I'd share with you guys.
I'm sure someone will find these useful.
The schematic is not in order but you get the gist
Working on swapping the 3uz-fe from my totalled GS430 into my Truck that currently does not have a motor.
Either way I needed the wiring diagrams and ecu pinouts for obvious reasons, so I figured I'd share with you guys.
I'm sure someone will find these useful.
The schematic is not in order but you get the gist
is there a third page to the actual pin out? Labeling wires using your post and noticed a lot of pins aren’t listed. Thanks
Thread
Thread Starter
Forum
Replies
Last Post