Electric Help Needed
Thread Starter
Driver
Joined: May 2014
Posts: 149
Likes: 0
From: NC
Electric Help Needed
Long story short I made a boo-boo with my retro-fit and put the turn signal tube in incorrectly so I can't put a turn signal light in. I don't want to try and re-open them because I sealed them really good and don't want the hassle and possible headache of re-opening them.
The only electrical info I know about the bulb is that it uses 1.85a @ 13.5v.
What size resistor would I need to fool the system and stop my rear signal and dash light from blinking so fast.
The only electrical info I know about the bulb is that it uses 1.85a @ 13.5v.
What size resistor would I need to fool the system and stop my rear signal and dash light from blinking so fast.
Thread
Thread Starter
Forum
Replies
Last Post
