View Poll Results: How did you attach your TTE front lip?
I molded that SOB on!
4
19.05%
Just the supplied adhesive.
2
9.52%
I used the supplied stuff then bolted it.
1
4.76%
I/bodyshop used some extra sticky stuff.
4
19.05%
I/bodyshop used sticky stuff and bolted it.
6
28.57%
Don't know but it hasn't fallen off yet. 
4
19.05%
Voters: 21. You may not vote on this poll
How did you attach your TTE front lip????
Lexus Test Driver
Joined: Feb 2002
Posts: 831
Likes: 0
From: New York
I just had the bodyshop put it on w/the adhesive that came with it but I told him to use whatever he felt would stick to assist w/the adhessive. I was told some people had difficulty w/it but it's been 4 mos already and no problems.....my guy at the shop assured me though that it wouldn't ever fall off....maybe majic???
Danny
Danny
Driver School Candidate
Joined: Sep 2001
Posts: 48
Likes: 0
From: California
the epoxy that comes with the tte blows. i resorted to drilling holes on the bottom of the lip with about 10 3" flat head screws up through and into stock bumper. to achieve this, i had the lip held on by the 5 screws that come with it (predrilled) and then used clamps to hold lip tight to bumper. then jacked car up on each side. then used drill bit to set holes through lip. then drilled in screws.
Thread
Thread Starter
Forum
Replies
Last Post
zackteee
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
1
Jan 14, 2015 11:45 PM
