A340 Issues
#1
Pole Position
Thread Starter
iTrader: (2)
Join Date: Oct 2007
Location: GA
Posts: 210
Likes: 0
Received 0 Likes
on
0 Posts
A340 Issues
Hi my JZS147 friends!
You probably don't remember me as I've been away for what seems like eternity! The day has finally come to where my NA-T project is almost 100% complete! I finally put the motor and trans in the car and the motor runs and sounds good! The only issue is the trans....it seems like it is in limp mode or trying to start off in 3rd gear. I did a search on here and didn't really find anything.
I have a built A340 trans, fresh torque converter, and have AEM V2 for tuning. I'm not getting any codes or have the flashing O/D light as I've seen online. I'm pretty much building boost, and it's barely getting out of its own way!
Does anyone have any suggestions what the issue can be? Do I need to adjust line pressure or possibly replace the solenoids? The transmission was originally built by BL and then I had it freshened up locally with some billet internals. I've reached back out to the guy but haven't heard from him yet.
I'm so close to being able to drive it, it's killing me! But I guess I waited so many years, what's another few weeks
You probably don't remember me as I've been away for what seems like eternity! The day has finally come to where my NA-T project is almost 100% complete! I finally put the motor and trans in the car and the motor runs and sounds good! The only issue is the trans....it seems like it is in limp mode or trying to start off in 3rd gear. I did a search on here and didn't really find anything.
I have a built A340 trans, fresh torque converter, and have AEM V2 for tuning. I'm not getting any codes or have the flashing O/D light as I've seen online. I'm pretty much building boost, and it's barely getting out of its own way!
Does anyone have any suggestions what the issue can be? Do I need to adjust line pressure or possibly replace the solenoids? The transmission was originally built by BL and then I had it freshened up locally with some billet internals. I've reached back out to the guy but haven't heard from him yet.
I'm so close to being able to drive it, it's killing me! But I guess I waited so many years, what's another few weeks
#3
Pole Position
Thread Starter
iTrader: (2)
Join Date: Oct 2007
Location: GA
Posts: 210
Likes: 0
Received 0 Likes
on
0 Posts
Thanks man! After doing some more research on Supraforums I did see that there was a hardware update available. I emailed tech support to see if it is still available. I sure hope it is something as simple as updating the box.
Thread
Thread Starter
Forum
Replies
Last Post
hydromatic
RX - 1st Gen (1999-2003)
9
07-01-19 05:19 PM