I'm currently doing an NA-T swap and have a question regarding transmissions.

I pulled this transmission out of my stock GS300 and it has a J2 stamp on the bellhousing. It has a 3 bolt flange to mount to the driveshaft.


This is a Boostlogic rebuilt NA transmission that I bought from a local guy off ClubNA-T. This came out of his NA Supra and has a J1 stamp on the bellhousing. This one has a slip yoke for the driveshaft. They both have an A340E badge.


I just want to clarify that the one I bought (pictured above) is actually from an NA Supra? Reason I'm asking is that a couple of the sensors aren't the same and I don't know which transmission (car) I need to look up for the wiring diagrams. I know that I'm going to have to get a custom driveshaft made now.

If anyone has any wiring diagrams, I would really appreciate it!

 

was that trans out of a RHD vehicle? or is the shift linkage the same on RHD and LHD?

 

That I'm not sure, but if you're standing right behind the trans, the shift linkage is on the right side on both tranny's.

 

Just swap the Yoke. use your GS300 yoke on the built tranny

 

did swapping the yoke worked?