Notices
ES - 1st to 6th Gen (1990-2018) Forum for all 1990 - 2018 ES Models

Interior Refresh

Thread Tools
 
Search this Thread
 
Old Jun 16, 2021 | 08:32 AM
  #1  
Funkdawg's Avatar
Funkdawg
Thread Starter
Rookie
5 Year Member
Liked
Loved
Community Favorite
 
Joined: Nov 2015
Posts: 39
Likes: 6
From: Texas
Default Interior Refresh

Just dropped off the wife’s car for it to be cleaned and detailed by a local company called AI Autoworks.
I used them to clean and detail then replace the headliner in a ‘03 VW Jetta I had for 17 years before selling it to a co-worker before buying another vehicle.

Looking forward to the end result later on today.

Last edited by Funkdawg; Jun 16, 2021 at 08:46 AM.
Reply
Old Jun 16, 2021 | 09:39 PM
  #2  
vbacky's Avatar
vbacky
Rookie
 
Joined: Aug 2008
Posts: 49
Likes: 0
From: Quebec
Default

Before & after pics?
Reply
Old Jun 17, 2021 | 06:52 AM
  #3  
Funkdawg's Avatar
Funkdawg
Thread Starter
Rookie
5 Year Member
Liked
Loved
Community Favorite
 
Joined: Nov 2015
Posts: 39
Likes: 6
From: Texas
Default

Originally Posted by vbacky
Before & after pics?
No interior before pictires to post.
En route to pick up the car now.
I'll take some after shots.
Reply
Old Jun 17, 2021 | 08:17 AM
  #4  
Funkdawg's Avatar
Funkdawg
Thread Starter
Rookie
5 Year Member
Liked
Loved
Community Favorite
 
Joined: Nov 2015
Posts: 39
Likes: 6
From: Texas
Default

The interior looks a lot better but there were still some stubborn staining that remains.






Reply
Old Jun 17, 2021 | 05:17 PM
  #5  
rickster9's Avatar
rickster9
Pit Crew
10 Year Member
Liked
Loved
Community Favorite
 
Joined: Nov 2013
Posts: 138
Likes: 5
From: Florida
Default

Originally Posted by Funkdawg
The interior looks a lot better but there were still some stubborn staining that remains.
I'm going to wash mines today some time.
Reply
Old Jun 17, 2021 | 09:28 PM
  #6  
Hayk's Avatar
Hayk
Lead Lap
15 Year Member
Shutterbug
Liked
Loved
iTrader: (1)
 
Joined: Feb 2009
Posts: 4,118
Likes: 311
From: NJ
Default

Originally Posted by Funkdawg
The interior looks a lot better but there were still some stubborn staining that remains.





Not sure if you’re up to this, but the seatbelt can be unbolted from the seat, pulled out of the car, and power washed or scrubbed by hand. I did that to mine and they look brand new. Looks like yours could use a clean.

As for the carpet stains, rent a Rug Doctor from a home improvement or grocery store with the appropriate cleaner and anti-foaming chemicals. It does an amazing job on carpet stains. A drill brush or a regular stiff bristle brush would also help with pulling the dirt out.
Reply
Old Jun 17, 2021 | 11:34 PM
  #7  
Zereldo's Avatar
Zereldo
Pit Crew
5 Year Member
Liked
Loved
Community Favorite
 
Joined: Oct 2018
Posts: 185
Likes: 28
From: Ontario
Default

Originally Posted by Hayk
Not sure if you’re up to this, but the seatbelt can be unbolted from the seat, pulled out of the car, and power washed or scrubbed by hand. I did that to mine and they look brand new. Looks like yours could use a clean.

As for the carpet stains, rent a Rug Doctor from a home improvement or grocery store with the appropriate cleaner and anti-foaming chemicals. It does an amazing job on carpet stains. A drill brush or a regular stiff bristle brush would also help with pulling the dirt out.
I removed the interior trim pieces covering the seatbelt mechanism (B pillar) to get access to the part of the seatbelt that is otherwise inaccessible.

Is it safe to remove seatbelts? Should the battery be disconnected? Will the seatbelts need to be properly torqued back? Or is it just a matter of unboltong, washing and installing back.

While mine are quite clean, I would prefer to soak them into a cleaner. Alternatively I may even entertain the idea of replacing the front seatbelts as they are quite worn.
Reply
Old Jun 19, 2021 | 09:56 PM
  #8  
Hayk's Avatar
Hayk
Lead Lap
15 Year Member
Shutterbug
Liked
Loved
iTrader: (1)
 
Joined: Feb 2009
Posts: 4,118
Likes: 311
From: NJ
Default

Originally Posted by Zereldo
I removed the interior trim pieces covering the seatbelt mechanism (B pillar) to get access to the part of the seatbelt that is otherwise inaccessible.

Is it safe to remove seatbelts? Should the battery be disconnected? Will the seatbelts need to be properly torqued back? Or is it just a matter of unboltong, washing and installing back.

While mine are quite clean, I would prefer to soak them into a cleaner. Alternatively I may even entertain the idea of replacing the front seatbelts as they are quite worn.
There is definitely a torque spec and it's recommended to disconnect the battery for safety. I personally winged it and kept the battery connected and tightened the bolt by feel.

Also, disconnect the belt from the seat bottom not from the B pillar. The B pillar is where the pre-tensioner assembly is so it's much more difficult to remove that way.
Unbolt from the seat bottom and pull the belt all the way out.





Here is the official wording from the repair manual:

Seat Belt Arming and Disarming
Wait at least 90 seconds after the engine switch is turned off and the negative (-) terminal cable is disconnected from the battery before starting the operation.

CAUTION:
* The vehicle is equipped with a Supplemental Restraint System (SRS). It consists of a driver airbag, front passenger airbag, driver side knee airbag, front passenger side knee airbag, front side airbag, rear side airbag, curtain shield airbag, front seat belt pretensioner, and rear seat belt pretensioner. Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing, possibly leading to a serious accident. Furthermore, if a mistake is made when servicing the SRS, it is possible that the SRS may fail to operate when required. Before performing servicing (including removal or installation of parts, inspection or replacement), be sure to read the following items carefully, then follow the procedures exactly as indicated in the repair manual.

*(The SRS is equipped with a backup power source, so if work is started within 90 seconds after disconnecting the negative (-) terminal cable from the battery, the SRS may be deployed.)

Torque spec

Last edited by Hayk; Jun 19, 2021 at 10:01 PM.
Reply
Old Jun 20, 2021 | 12:35 PM
  #9  
Funkdawg's Avatar
Funkdawg
Thread Starter
Rookie
5 Year Member
Liked
Loved
Community Favorite
 
Joined: Nov 2015
Posts: 39
Likes: 6
From: Texas
Default

Originally Posted by Hayk
Not sure if you’re up to this, but the seatbelt can be unbolted from the seat, pulled out of the car, and power washed or scrubbed by hand. I did that to mine and they look brand new. Looks like yours could use a clean.

As for the carpet stains, rent a Rug Doctor from a home improvement or grocery store with the appropriate cleaner and anti-foaming chemicals. It does an amazing job on carpet stains. A drill brush or a regular stiff bristle brush would also help with pulling the dirt out.
I just cleaned the driver's side seatbelt just now.
Used a cleaner my wife had called "The Amazung Whip It".
Worked pretty good on the stubborn stains in the carpet.
The seatbelt, not so much.
Also tried Resolve carpet cleaner.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Bunz617
CT 200h Model (2011-2017)
3
Jun 14, 2021 04:39 PM
Nick@Autogeek
Club Lexus Vendor Marketplace
1
Jul 11, 2012 05:37 AM
TJohnson
SC - 1st Gen (1992-2000)
32
Sep 23, 2009 11:16 AM
AutoCoutureSC
SC400 / 300 Classifieds
22
Apr 26, 2006 04:05 PM




All times are GMT -7. The time now is 05:17 PM.