AeroTect - Version 2.0
#18
I need to redo a few areas that I messed up (ended up with a couple of bubbles from the glue getting chunky...if that makes any sense).
At the same time, there's a few areas that the neffy didn't conform very well (around the edges of the cup holder and a few other spots).
While the neffy looks good, I figured I'd try this stuff since it seems to conform better around curves and corners.... I'll do a write up to compare the 2 types once I get some of this stuff to try out.
At the same time, there's a few areas that the neffy didn't conform very well (around the edges of the cup holder and a few other spots).
While the neffy looks good, I figured I'd try this stuff since it seems to conform better around curves and corners.... I'll do a write up to compare the 2 types once I get some of this stuff to try out.
#19
Pole Position
iTrader: (1)
Join Date: Jun 2007
Location: CA
Posts: 259
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Jason and Francisco! Put up the pictures on here when you can - https://www.clublexus.com/forums/is-...l-covered.html - a little review, but I'll go more in-depth about it later.
#21
I should get my order this week too.... can't wait to see how it compares to the neffy wrap.... although I will have to strip off the old adhesive from the neffy wrap and I'm not looking forward to that.
Thread
Thread Starter
Forum
Replies
Last Post