UW IS "Build" :wiggle:
#1
Lexus Test Driver
Thread Starter
UW IS "Build" :wiggle:
I've been using this forum for quite some time. Think I should make a build thread.
'16 IS350 FSPORT, Ultra White with Black Interior.
Fully Loaded (NA Specs), BSM, PCS, DRCC, ML
Current
3M Ceramic, 35% all around
Aimgain rep front lip
FSPORT axleback
FSPORT Shock Absorbers
FSPORT Lowering Springs
DCTMS Carbon Fiber/Flat Bottom steering wheel
Carbon Fiber Shift ****
Winjet foglights
Next "wants"
19 x 8.5 +35 (squared wheel setup, leaning towards Rohana Rfx5)
235/35/19 PSS or PS4S (when stock tires goes)
"Some kind" of side skirts..
Couple Pic's I had on my phone
DAY 1 - 9/16 after installing the suspension parts (Barely a noticeable difference lol, hopefully settles a bit more. Car handles way better with the FSPORT spring/shock combo, and has a stock ride feel)
NOTE: the pic below is filtered with more lightning so y'all can see the wheel gap.
DCTMS
'16 IS350 FSPORT, Ultra White with Black Interior.
Fully Loaded (NA Specs), BSM, PCS, DRCC, ML
Current
3M Ceramic, 35% all around
Aimgain rep front lip
FSPORT axleback
FSPORT Shock Absorbers
FSPORT Lowering Springs
DCTMS Carbon Fiber/Flat Bottom steering wheel
Carbon Fiber Shift ****
Winjet foglights
Next "wants"
19 x 8.5 +35 (squared wheel setup, leaning towards Rohana Rfx5)
235/35/19 PSS or PS4S (when stock tires goes)
"Some kind" of side skirts..
Couple Pic's I had on my phone
DAY 1 - 9/16 after installing the suspension parts (Barely a noticeable difference lol, hopefully settles a bit more. Car handles way better with the FSPORT spring/shock combo, and has a stock ride feel)
NOTE: the pic below is filtered with more lightning so y'all can see the wheel gap.
DCTMS
Last edited by nathantse; 10-22-17 at 10:34 PM.
#2
Your #1 Lexus Vendor
iTrader: (8)
Nice start!
Let us know if you need any parts!
-Josh
Let us know if you need any parts!
-Josh
__________________
Your #1 Dealer for Aftermarket Performance Products
Orange County, CA
Email: info@merakiautoworks.com
Text/Call: 213 394 2886
Website: www.MerakiAutoworks.com
Your #1 Dealer for Aftermarket Performance Products
Orange County, CA
Email: info@merakiautoworks.com
Text/Call: 213 394 2886
Website: www.MerakiAutoworks.com
The following users liked this post:
nathantse (09-19-17)
#3
Lexus Test Driver
Thread Starter
#5
Lexus Test Driver
Thread Starter
#6
Pole Position
haha, i want to change out my steering wheel but i'm also afraid of the airbag. it's going to go off in my face! nah, i mean, i'm still afraid of it, but it's not going to go off in my face (hopefully).
Trending Topics
#8
Lexus Test Driver
Thread Starter
UPDATED: 9/24 (about a week since initial install)
Here are some pics of the fsport springs (lighting adjusted to see gap).
FSPORT SPRINGS DAY 7 (Front) FSPORT SPRINGS DAY 7 (Rear)
Here are some pics of the fsport springs (lighting adjusted to see gap).
FSPORT SPRINGS DAY 7 (Front) FSPORT SPRINGS DAY 7 (Rear)
#10
Lexus Test Driver
Thread Starter
Got plans to put 19s on it, which hopefully closes the gap a little more too. I've seen pics of RSR Half Downs (as mild drop as fsport springs) with 19s, and they look goooooooood.
#11
Pole Position
Yup, its subtle. Hopefully settles a tad more by 1 month (Like Leo's car). But I'll keep checking. Other than that, the car handles superb, and rides like stock.
Got plans to put 19s on it, which hopefully closes the gap a little more too. I've seen pics of RSR Half Downs (as mild drop as fsport springs) with 19s, and they look goooooooood.
Got plans to put 19s on it, which hopefully closes the gap a little more too. I've seen pics of RSR Half Downs (as mild drop as fsport springs) with 19s, and they look goooooooood.
#12
Lexus Test Driver
Thread Starter
But, I'm leaning towards these (Rohana RFX5)... Any other suggestions would be great! (trying to keep wheel/tires under 3k)
#15
Lexus Test Driver
Thread Starter
Winjet Fog lights
Winjet Fog Lights installed by specONE. Thanks again!
Fit is very good, a lot better than what I had seen with iJDMtoys. The Winjet kit came with holagen bulbs, I think they were 4300k. SpecONE had some LEDs laying around, and we swapped it in. Its a whiter LED, think the output is 5k or 6k. (Didn't quite look at the box).
Matches the headlights quite well.
Fit is very good, a lot better than what I had seen with iJDMtoys. The Winjet kit came with holagen bulbs, I think they were 4300k. SpecONE had some LEDs laying around, and we swapped it in. Its a whiter LED, think the output is 5k or 6k. (Didn't quite look at the box).
Matches the headlights quite well.