Ah yet another build thread!
#127
Pole Position
Thread Starter
Join Date: Mar 2010
Location: Co
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Got those badboys in. adjustable swaybar endlinks for a toyota supra. i needed them badly because with the car so low i know my swaybar was preloaded and affecting the turn in on my front end. now i have no preload and turn in is better
install went smoothly. made sure i had the car on ramps and weight on the wheels when i was installing the endlink so preload would be zero.
also the noise i got when full lock is gone ^_^
#129
Pole Position
Thread Starter
Join Date: Mar 2010
Location: Co
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Thanks homie!
Did this this morning! (strut bar if you can't tell) they are hard to come by for the 400 -_-
You can DEFINITELY feel it in corners and over bumps. Again I installed this with the car jacked up and with wheels clear of the ground so there isn't any preloaded on the suspension.
Did this this morning! (strut bar if you can't tell) they are hard to come by for the 400 -_-
You can DEFINITELY feel it in corners and over bumps. Again I installed this with the car jacked up and with wheels clear of the ground so there isn't any preloaded on the suspension.
Last edited by Sohconthis; 09-28-10 at 12:18 PM.
#131
Pole Position
Thread Starter
Join Date: Mar 2010
Location: Co
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Thanks! I haven't installed the supercharger yet. Still need the manifold and kit. The exhaust I would have to say is my best mod so far. I have dual hks hi-power mufflers. I don't think a lot of people have them.
#134
Pole Position
Thread Starter
Join Date: Mar 2010
Location: Co
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts