Drift/Vip styled 2000 Gs300 Build

Reply Subscribe

Thread Tools

Search this Thread

Sep 11, 2024 | 05:23 PM

#31

SoCal Cyco

Pole Position

iTrader: (20)

Joined: Dec 2007

Posts: 3,151

Likes: 50

From: SoCal

Looking good sir, what are the wheel and tire spec's if you don't mind? Thanks

Feb 20, 2025 | 11:34 PM

#32

preemoguru

Rookie

Joined: Jul 2022

Posts: 34

Likes: 2

From: TX

Quote:

Originally Posted by Lurkskywalker

I actually cut a small piece of wood and panel bonded it behind the little vertical support part of the bumper in between the fog light opening and large opening. Then I used a self tapper to attach the fog to the wood.

I can try and get a photo for you tonight when I get home.

sent you a pm, i had a few questions

Feb 21, 2025 | 01:56 PM

#33

Lurkskywalker

Thread Starter

Driver School Candidate

Joined: Nov 2023

Posts: 24

Likes: 14

From: Colorado

Quote:

Originally Posted by SoCal Cyco

Looking good sir, what are the wheel and tire spec's if you don't mind? Thanks

completely unsure if the offset cause the guy I bought them from didn’t know either. But they are 19x9/19x10 I am running 15mm spacers in the rear and will probably have to run spacers up front when I install the front upper control arms and dial more camber.

I installed some big boy exhaust tips to fill out the holes in the bumper. Kept the actual exhaust stock because I like how quiet the drive is.

I also had a buddy weld on a Jack point in the rear so I could get it off the ground without the wood which has been a life saver.

I had the local pinstriper in town give me a little badge on the rear deck lid.

That’s about all that’s been done to her for a while now, I’ve just been driving it around and enjoying it. I have done a couple photo shoots and cars and coffees, everyone seems to love it everywhere I go.