CA RX330 AFS HID Retrofit
#1
RX330 AFS HID Retrofit
NEW PRICE $600.....
I no longer have the car these lights were on so it's time to sell them. The lights are factory 98 HID headlights with the auto-leveling. They have been retrofitted using the RX330 AFS projectors and the brackets from Luxury Mods. They do not have the grommets on the back around the projector, I didn't need them but if you would like to use them they would cost $20 from Lexus. I had the cutoff shields professionally machined to remove the raised part of the shield on the sides for a flat wide cutoff, they have the color mod done as well. I'm asking $600 OBO plus shipping and Paypal fees.
Here is a parts breakdown:
RX330 AFS Projectors
TSX-R Clear Lenses
Factory Koito HID Ballasts
D2S: Morimoto 3Five 5000K Bulbs (35w)
Apollo Projector Shrouds
Factory HID Auto Leveling Lights
Luxury Mods Projector Retrofit Bracket
This Picture shows the small black scuff marks on the inside of the running light it is not very noticeable.
I no longer have the car these lights were on so it's time to sell them. The lights are factory 98 HID headlights with the auto-leveling. They have been retrofitted using the RX330 AFS projectors and the brackets from Luxury Mods. They do not have the grommets on the back around the projector, I didn't need them but if you would like to use them they would cost $20 from Lexus. I had the cutoff shields professionally machined to remove the raised part of the shield on the sides for a flat wide cutoff, they have the color mod done as well. I'm asking $600 OBO plus shipping and Paypal fees.
Here is a parts breakdown:
RX330 AFS Projectors
TSX-R Clear Lenses
Factory Koito HID Ballasts
D2S: Morimoto 3Five 5000K Bulbs (35w)
Apollo Projector Shrouds
Factory HID Auto Leveling Lights
Luxury Mods Projector Retrofit Bracket
This Picture shows the small black scuff marks on the inside of the running light it is not very noticeable.
Last edited by 98sscamaro; 11-04-13 at 02:13 PM. Reason: Price drop 11/4/13
#3
It is the very far side of the shield that has been cut to extend the width of the beam. This is a standard practice. Usually you can make your own shield to save the money I spent and also curve the shield. I didn't want to try and perfect my own shield so I just had the end cut off to widen it. See in the picture I have attached, where I put the red line. That is what was removed.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
zuluzulu
RX - 3rd Gen (2010-2015)
8
06-20-17 06:33 AM
coolhand
RX - 2nd Gen (2004-2009)
1
01-10-07 08:21 PM