CA SoCal 2nd Gen door actuator
#1
Lead Lap
Thread Starter
iTrader: (25)
Join Date: May 2009
Location: CA
Posts: 483
Likes: 0
Received 0 Likes
on
0 Posts
SoCal 2nd Gen door actuator
Picked up, MODS PLEASE CLOSE.
I recently had to replace the door actuator in my driver door in my 2nd gen GS300 (2002), the motor is still good the plastic peice that goes into the lock was broken only. If your local (San Diego) or want to pay $6 for shipping it's yours. I included a picture of the the broken plastic piece.
I recently had to replace the door actuator in my driver door in my 2nd gen GS300 (2002), the motor is still good the plastic peice that goes into the lock was broken only. If your local (San Diego) or want to pay $6 for shipping it's yours. I included a picture of the the broken plastic piece.
Last edited by importhope; 04-15-10 at 09:18 PM. Reason: Item is gone.
Trending Topics
#12
Lead Lap
Thread Starter
iTrader: (25)
Join Date: May 2009
Location: CA
Posts: 483
Likes: 0
Received 0 Likes
on
0 Posts
Glue wont hold for long... well maybe epoxy it before to get it to stay together, slide it in, and then lather it on thick after you slide it in place... although if it doesnt work the housing on the door handle will have to be cleaned, or possibly replaced. But that's the only way I could imagine it holding. Good luck.
#14
Lexus Fanatic
iTrader: (182)
Glue wont hold for long... well maybe epoxy it before to get it to stay together, slide it in, and then lather it on thick after you slide it in place... although if it doesnt work the housing on the door handle will have to be cleaned, or possibly replaced. But that's the only way I could imagine it holding. Good luck.
would that even hold it? u talking bout the heat shrink u run over wires?