CA GT35R Turbo Kit -Fits an IS300 too...+ AEM FIC & PnP 2JZ Injectors
#1
GT35R Turbo Kit -Fits an IS300 too...+ AEM FIC & PnP 2JZ Injectors
I bought this to install on my car but I think I'm going to go with another vehicle and use this car as a DD.
David H. "IS300ER" had this setup on his car prior to taking it off. I'm pretty sure the miles on it are pretty low, according to him the turbo was pretty much brand spankin new.
2550 shipped or 2450 picked up
Here are some pics
The AEM 30-1910 FIC I'll let go for 300 (all the GS300/IS300 groundouts have been done on it) Simple matter of PnP/splicing.
David H. "IS300ER" had this setup on his car prior to taking it off. I'm pretty sure the miles on it are pretty low, according to him the turbo was pretty much brand spankin new.
2550 shipped or 2450 picked up
-GT35R Turbo (A/R .76) with Polished Compressor housing & Anti-Rust Exhaust housing
-Toyomoto Tubular Exhaust Manifold
-Toyomoto 4" Down-Pipe
-HKS S-type Intercooler (w/ bracket)
-HKS Standard Wastegate (w/ adapter, flange, and 7~9psi spring)
-HKS Timing Belt
-Full Polished Aluminum Intercooler Pipings (from compressor to intercooler, and from intercooler to the intake manifold)
-All Rubber Hoses & Clamps & Bolts for the manifold/turbo
-Steel-Braided Oil Feed Line
-GReddy E-Manage with NEW Harnesses & Sensors that are available for the unit (usually they come separately and cost more than the unit)
-Toyomoto Tubular Exhaust Manifold
-Toyomoto 4" Down-Pipe
-HKS S-type Intercooler (w/ bracket)
-HKS Standard Wastegate (w/ adapter, flange, and 7~9psi spring)
-HKS Timing Belt
-Full Polished Aluminum Intercooler Pipings (from compressor to intercooler, and from intercooler to the intake manifold)
-All Rubber Hoses & Clamps & Bolts for the manifold/turbo
-Steel-Braided Oil Feed Line
-GReddy E-Manage with NEW Harnesses & Sensors that are available for the unit (usually they come separately and cost more than the unit)
The AEM 30-1910 FIC I'll let go for 300 (all the GS300/IS300 groundouts have been done on it) Simple matter of PnP/splicing.
Last edited by lexusscturbo; 01-02-10 at 06:20 AM.
Trending Topics
#8
So basically you'll need
-2 Walbro fuel pumps (at least for the GS300/IS300).
-Fuel Pressure Regulator
-A BOV of your choice
-Cosmetic HG / or OE Toyota 2JZGTE
-ARP headstuds..
(400whp safely)-