Seat removal DIY
#1
Seat removal DIY
This is on the passenger side and i would assume it is the same for the driver side.
Behind the seat with plastic covers
Remove this for more clearance
3 Bolts
Front plastic covers
Forgot to take pictures of the front bolts, but im sure you will know how the bolts look like.
I believe it was a 14mm for the bolts.
Should end up like this
I do have a question though, how would one go on replacing a motor though? There is so much crap in the way and there are multiply motors as well
Behind the seat with plastic covers
Remove this for more clearance
3 Bolts
Front plastic covers
Forgot to take pictures of the front bolts, but im sure you will know how the bolts look like.
I believe it was a 14mm for the bolts.
Should end up like this
I do have a question though, how would one go on replacing a motor though? There is so much crap in the way and there are multiply motors as well
Thread
Thread Starter
Forum
Replies
Last Post
SC400slide
SC- 1st Gen (1992-2000)
13
08-30-20 11:16 AM
TLW
GS - 2nd Gen (1998-2005)
16
08-03-05 02:23 PM