Question on how to modify fog lights to stay on with high beams
#1
Driver School Candidate
Thread Starter
Join Date: Jan 2015
Location: Ga
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Question on how to modify fog lights to stay on with high beams
I was wondering if anyone knew what steps are needed to modify a 2005 RX 330's fog lights to stay on with the high beams? I found the info on the web & did this modification to my 2010 Tundra but can not find any info pertaining to how to mod an RX. Any help with this would be greatly appreciated.
#2
I was wondering if anyone knew what steps are needed to modify a 2005 RX 330's fog lights to stay on with the high beams? I found the info on the web & did this modification to my 2010 Tundra but can not find any info pertaining to how to mod an RX. Any help with this would be greatly appreciated.
#3
I had a 2000 Tundra some years back and the mod was to remove the fog light relay which was located in a fuse and relay box under the hood, then jumper wire between the two large spade terminals, leaving the other two smaller spade terminals alone. Worked great. When I sold the Tundra, I pulled the jumper wire and replaced the stock relay. I wonder if it works the same way in a 2015 RX 350. Regardless of whether "fog lights" should or should not turn on with high beams, I'd like to run them whenever any lights are on, parking light, low beam or high beam.
Thread
Thread Starter
Forum
Replies
Last Post
Chris442
IS - 3rd Gen (2014-present)
2
12-31-15 05:00 PM