edupim

hi, doing a inspecyion i found the engine support with gap
i m showing with a screwdriver just to show.
my question is. is it normal or i have to change this support
below the photos

2GSKaizen

iTrader: (1)

The mount on those top 3 pictures is fine. When those mounts start going bad they tear the rubber between the top "V" shaped metal plate, and that bottom "W" shaped metal plate. That suspension arm in the last picture is completely trashed. That is so bad it's a safety concern. Get a new one before it falls off!

edupim

ok thank you a lot .
do you know if it is possible to change only the mount or i have to change all suspension arm
do you know the part 'name to buy in amazon
thanks again

Lexmex

The suspension arm is one unit, you can't replace that one bad round bushing you see there.

edupim

good advise.
People in ebay sells only the bushing
here in brasil they installs using strong pressure and say (rthat is it 'have a nice trip")