rubber engine support
#1
Rookie
Thread Starter
rubber engine support
hi, doing a inspecyion i found the engine support with gap
i m showing with a screwdriver just to show.
my question is. is it normal or i have to change this support
below the photos
i m showing with a screwdriver just to show.
my question is. is it normal or i have to change this support
below the photos
#2
Lead Lap
iTrader: (1)
The mount on those top 3 pictures is fine. When those mounts start going bad they tear the rubber between the top "V" shaped metal plate, and that bottom "W" shaped metal plate. That suspension arm in the last picture is completely trashed. That is so bad it's a safety concern. Get a new one before it falls off!
#3
Rookie
Thread Starter
ok thank you a lot .
do you know if it is possible to change only the mount or i have to change all suspension arm
do you know the part 'name to buy in amazon
thanks again
do you know if it is possible to change only the mount or i have to change all suspension arm
do you know the part 'name to buy in amazon
thanks again
#4
Super Moderator
Thread
Thread Starter
Forum
Replies
Last Post