DIY midpipe swap advice
#1
Rookie
Thread Starter
DIY midpipe swap advice
I have an IS250 2012 and need to swap out my midpipe and wanted to do this at home. I have (4) 3-ton jack stands and a hydraulic jack.
So, can I do this myself and which end is best to lift up if I plan to only lift one end? Front, back or do both at separate times? I was thinking front end.
And is this ok to do this myself?
I am reinstalling my OEM midpipe and removing the Invidia midpipe, too raspy, too much drone.
Thanks,
Mike
So, can I do this myself and which end is best to lift up if I plan to only lift one end? Front, back or do both at separate times? I was thinking front end.
And is this ok to do this myself?
I am reinstalling my OEM midpipe and removing the Invidia midpipe, too raspy, too much drone.
Thanks,
Mike
#3
Instructor
i just jack the front on my is350 and i had enough space to pull the whole mid pipe out...
Last edited by 604GSE21; 05-02-16 at 08:27 PM.
#5
Lexus Champion
Jack up driver side front. That the only one you need. I also have invidia midepipe with Tanabe exhaust it took about 2 week for the noise to quite down, and relearn. First week was load and annoying.
#6
Rookie
Thread Starter
- Mike
Thread
Thread Starter
Forum
Replies
Last Post