Rock's SC install is finally done!
#76
Racer
iTrader: (19)
I'm working on getting an appointment for a final professional tune. Just got my new rubber installed (BS S-04 Pole Positions). So, as soon as I get a good tune I will post up some awesome videos. I promise.
I can push the car a bit but it's only easing into boost and usually let off at 5lbs; still puts me back into my seat though.
However, I don't fully trust my tune to really get on it. I came so far and don't want to blow my engine. Lol. I tried a few times just mashing the gas at WOT and the car bucked and bogged a bit, too little and too much fuel and probably not a smooth enough fuel/ignition curve. This is why I need a professional dyno tune. The tune I did is safe, very rich, very drivable, no codes now for over 6mos and passed NYS inspection with this so called seemingly impossible FIC piggyback. It works as advertised, as long as it's wired and setup properly. Which took me a very long time to hash out.
I will deliver...don't lose faith!
I can push the car a bit but it's only easing into boost and usually let off at 5lbs; still puts me back into my seat though.
However, I don't fully trust my tune to really get on it. I came so far and don't want to blow my engine. Lol. I tried a few times just mashing the gas at WOT and the car bucked and bogged a bit, too little and too much fuel and probably not a smooth enough fuel/ignition curve. This is why I need a professional dyno tune. The tune I did is safe, very rich, very drivable, no codes now for over 6mos and passed NYS inspection with this so called seemingly impossible FIC piggyback. It works as advertised, as long as it's wired and setup properly. Which took me a very long time to hash out.
I will deliver...don't lose faith!
Thread
Thread Starter
Forum
Replies
Last Post
toy4life86
Northern California Lexus Club
2
06-18-11 11:17 PM