joezhu110

i been doing for a day didnt know how to make it work
i have ask couple of friend they said just get the bubbles out that will work but i try whole day that see no different
is any one swap w58 before how do u make the thowout bearing works
bought the part from
http://www.xcessivemanufacturing.com/home.html


anyone know please help thanks

Slid3ways

You cant bleed the clutch if the tranny isnt on.

You bleed it from the slave cylinder on the transmission. There is a valve threaded in it, you loosen and tighten to bleed it.

And those first two pics... i dunno what the hell that goes to bc that does not go anywhere near a w58

joezhu110

i have put the tranny on and try couple time already but still the same and we took out to try
i been replace the new bearing from the store its not the bearing problem also i go autozone bought another same part is stil the same i dont think thats any part damage all part bought brand new
that s another way to try ?

aTeAse

Why do I feel like this doesn't belong here..

Whoareu

i had the same problem when i did the w58 1uzfe swap
first things first make sure u have the lines connected right i will give the link to my post

1.open bleeder valve on the line
2.press clutch in
3.close bleeder valve
4.pump the clutch might have to help it up again the first few times
5.make sure the clutch engages and if the car feels weird on gear re do it again took me like 5 time to get it right

Whoareu

https://www.clublexus.com/forums/sc-...to-swap-8.html

this is what i have done so far not done yet just need to install exhaust and pass smog lol

Whoareu

the first time i put on the tranny wouldnt engage i had the line the wrong way somewhere im my post i put what side is for what hope that helps

Whoareu

By the pic u have i think u have the lines crossed if u didnt get any pressure just sound like it was trying to get it then for sure its crossed