Relocate or protect yellow airbag cable in pass wheel well?
#1
Relocate or protect yellow airbag cable in pass wheel well?
Hi,
I lowered the car more than usual last week. The driver side harness is still safe (i check it daily and plan relocation soon) but the yellow SRS cable in the passenger well has rubbed the yellow protector off. I am going to remove the wheel and raise the coil over tomorrow and also check the cable inside but so far it looks like just the yellow cover is worn away. Is there a DIY for relocation of this harness? Please tell me whatever you know about this cable and protecting it. is there only one cable inside?
Thank you
SG
I lowered the car more than usual last week. The driver side harness is still safe (i check it daily and plan relocation soon) but the yellow SRS cable in the passenger well has rubbed the yellow protector off. I am going to remove the wheel and raise the coil over tomorrow and also check the cable inside but so far it looks like just the yellow cover is worn away. Is there a DIY for relocation of this harness? Please tell me whatever you know about this cable and protecting it. is there only one cable inside?
Thank you
SG
#5
Not now at least, I raised it today. I think without the liner, even when 100% even, that yellow cable was more vulnerable than the other harness because it does not have the white plastic block covering it, just the (now missing) black plastic liner and the yellow cable protector.
Thanks
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
htakhar92
SC- 1st Gen (1992-2000)
3
07-16-12 03:01 PM
SuicidnS13
SC- 1st Gen (1992-2000)
13
08-14-10 11:30 PM