thebadz32

iTrader: (5)

What can i do to fix this? just a new gasket do i have to pull the intake to pull the valve cover??? need help before i decide to get into this.

Thanks

DryBlaze

Most likely the O ring but if there is oil around your valve covers I would replace the gaskets as well.

Zeal3

iTrader: (1)

its most likely the O ring i changed mine in 30 minutes.
for a whole pack it cost $3 at autozone.
oh and theres a write up on how to do it.

KoSC300

i think i need to change my O-ring as well, have alot of build up by my distributor. wheres that write up at? i know i know, im searching as i type.

5sp_jzz30

iTrader: (2)

how to change the dist o-ring:

1. put the motor on tdc
2. take off the distributor cap
3. the rotor will be at the 1 o'clock position when the motor is on TDC
4. remove the 12mm nut and pull out the whole assembly
5. replace o-ring and reinstall distributor
6. after reassembly use a timing light to make sure the ignition timing is right.

good luck

IS_Sunny

iTrader: (1)

Distributor O-Ring leak?

Zeal3

iTrader: (1)

yup thats from the distributor.
better fix it before it damages ur alternator. bcs thats just adds on to the work.

ScWift92

hate to bump this but can this cause a misfire?