R154 pricing question guys
#1
R154 pricing question guys
Hey guys I have strongly been debating on switch to a th400 or a v160 for my power goals and it has been weighing heavily on my mind. So i need your guys help! So i have the thought of selling an entire r154 setup. The r154 included is fresh with MC parts it's a soarer r154 at that, It would come with trans, Arp flywheel bolts, fresh rebuilt ACT extreme PP from South bend, South Bends strongest 6 puck Feramic clutch disk, fresh resurfaced Chromoly steel LW flywheel, hub assembly with brand new snap rings, clutch Fork, Slave cylinder, DM bellhousing, Half shaft, Shifter, trd shift ****, OEM rear main seal, basically everything and have receipts.
What would be a good price on this guys? I've seen prices all over the place just wanted an idea before I possibly make my decision, These parts currently have 0 miles. Also if i go th400 i will sell the pedal setup etc. You guys are great and thanks.
What would be a good price on this guys? I've seen prices all over the place just wanted an idea before I possibly make my decision, These parts currently have 0 miles. Also if i go th400 i will sell the pedal setup etc. You guys are great and thanks.
#2
1JZ Single SC400
iTrader: (59)
Join Date: Jan 2009
Location: Alabama, Roll Tide!
Posts: 8,518
Likes: 0
Received 15 Likes
on
12 Posts
I am thinking around 1400-1700, just cause you have all new parts for the most parts. IMO, I would keep it. They are great transmissions and hold power very well. Another great thing is that the gears are long!
#6
Lexus Test Driver
iTrader: (16)
If you're selling a complete swap. I would guess 2k-2500 being its lot of quality parts, a fresh rebuilt marlin crawler r154, pedal, clutch etc. A mkiii r154 without 1jz bell housing goes for roughly 400 without guarantee of its condition. So 2k-2500 is a good price. eBay prices are even higher than what I listed above.
#7
Jwin is right 2k-2500..... r154 around my neck of the hood go for like 650 or 700..... with a 7m housing and so forth and so forth..... do the math of all the parts you would need. $$$$$$$
Thread
Thread Starter
Forum
Replies
Last Post