Question for experienced compressor map readers...
#1
Lead Lap
Thread Starter
Join Date: Jun 2006
Location: GA
Posts: 442
Likes: 0
Received 0 Likes
on
0 Posts
Question for experienced compressor map readers...
on a 1uz-fe, what can you expect as far as spool to ~10psi with a single GT35R setup? here's the compressor map
Last edited by Durrr; 04-29-09 at 05:56 PM.
#2
Lead Lap
Thread Starter
Join Date: Jun 2006
Location: GA
Posts: 442
Likes: 0
Received 0 Likes
on
0 Posts
Well, I kinda answered my own question, should see positive pressure ~ 2500 rpm with full boost by 3000. At 11psi, flow rate is about 40lbs/min. Might not be large enough for a single application.... I would ultimately like to find a twin application as it would be more balanced for what I'm attempting to do.
Thread
Thread Starter
Forum
Replies
Last Post