1uz-fe head studs (ARP)
#1
Lead Lap
Thread Starter
iTrader: (2)
Join Date: Dec 2006
Location: nv
Posts: 543
Likes: 0
Received 0 Likes
on
0 Posts
1uz-fe head studs (ARP)
does anyone have any link to ARP head studs for the 1uz-fe?
i heard you can use the VQ35 head studs? i know they come in 16 but i think we need 20 (10 on each head).
are the stock head bolts re-useable? torque specs? 90 lbs?
i heard you can use the VQ35 head studs? i know they come in 16 but i think we need 20 (10 on each head).
are the stock head bolts re-useable? torque specs? 90 lbs?
#3
currently expanding my knowlege on the sc300 but from my general knowlege of factory head bolts, they will stretch and should only be used once. You might be able to measure and see if the head bolt has stretched out of spec but better to use new bolts.
arp head bolts are said to not stretch.
arp head bolts are said to not stretch.
#6
Lexus states to only replace the head stud if it doesn't measure up, or if it feels as if it stretches during installation.
They do reuse them.
I have ran 17PSI on my SC400 1UZ and they still measure up OK.
I did replace them with stock Lexus head bolts with the rebuild.
The torque spec is 20 ft-lbs, and then an additional 90 degrees, but double check that, cause I'm going off of memory.
They do reuse them.
I have ran 17PSI on my SC400 1UZ and they still measure up OK.
I did replace them with stock Lexus head bolts with the rebuild.
The torque spec is 20 ft-lbs, and then an additional 90 degrees, but double check that, cause I'm going off of memory.
Thread
Thread Starter
Forum
Replies
Last Post