Does Anyone Know What the Factory Specs are for Toe and a Camber for the '01 IS300??
#1
Driver
Thread Starter
Join Date: Jun 2001
Location: Pluto
Posts: 143
Likes: 0
Received 0 Likes
on
0 Posts
Right now my front wheels are Toe-in: +0.25 on both sides, Camber: 0
Rear Wheels: Toe: 0, Camber: -1.38 on both sides.
I feel that there is way too much negative Camber on my rear wheels. Does anyone have the specs? Do not want to pay dealer $160 for four wheel alignment and other folks do not have specs for '01 IS300 yet.
Side note, did not know our cars had it until vehicle was on a lift, however we have adjustments for Camber!!!
No Camber kits necessary! Thanks Everyone.
N1
Rear Wheels: Toe: 0, Camber: -1.38 on both sides.
I feel that there is way too much negative Camber on my rear wheels. Does anyone have the specs? Do not want to pay dealer $160 for four wheel alignment and other folks do not have specs for '01 IS300 yet.
Side note, did not know our cars had it until vehicle was on a lift, however we have adjustments for Camber!!!
No Camber kits necessary! Thanks Everyone.
N1
Thread
Thread Starter
Forum
Replies
Last Post
N10S1
IS - 1st Gen (2001-2005)
3
08-01-01 12:20 AM